Siemens SINUMERIK 805 Operating Instructions Manual page 214

8 Monitoring
8.3.3 List of alarms
06.90
2066
Thread lead increase/decrease
too
high
Scan:
Effect:
Explanation:
On traversing in
AUTOMATIC/MDA mode
Interlocking of NC START
A thread lead or pitch increase or
decrease of more than 1 6 mm/rev
(0.6"/rev) has been programmed
Program a smaller thread lead increase/decrease Remedy:
2067
Max. speed of one axis
= 0
Scan:
Effect:
Explanation:
On traversing in AUTOMATIC/MDA
Interlocking of NC START
An axis
with
a maximum speed of zero has been
programmed in the
block
Check
MD
Remedy:
2068
Prog, position behind working area limit
Scan:
Effect:
On
traversing in
AUTOMATIC/MDA
mode
-
Interlocking of NC START
-
The
programmed path has not been executed
The programmed block end point is in one or several axes behind the
working area limit
-
Check working area limit
(plus and minus)
-
After working area limit in the program
with
G25/G26
Explanation:
Remedy:
2072
Incorrect input value (Blue print prog.)
Explanation :
Input for contour definition cannot be calculated
2073
No intersection point (Blue print prog.)
Calculation of the contour definition gives no intersection point with the
values programmed
Explanation:
2074
Incorrect angle value (Blue print prog.)
Angle > 360° programmed
Angle value for the contour described
not
logical
Explanation:
8-21
©
Siemens AG 1990 All Rights
Reserved 6ZB5410-0EE02
SINUMERIK
805,
SW2 (BA)