Siemens SINUMERIK 805 Operating Instructions Manual page 211

06.90
8 Monitoring
8.3.3 List of alarms
2040
Block
not
in memory
Interlocking of
NC START
-
The block
number sought in program with block search is
not
in the
memory.
-
The
programmed block number could
not
be found with the jump
function in the given direction.
Effect:
Explanation:
2041
Program
not
in memory
Effect:
Explanation:
Interlocking of NC START
-
The preselected program is not in the memory
-
The subroutine called
in the main program
is
not
in the memory
Look
at
"Main programs" and "Subroutines"
overview.
Remedy:
2042
Parity error in memory
Scan:
Explanation:
During machining in AUTOMATIC mode
One or more characters
have been deleted in the memory so that
they
can no longer be recognized (these characters are
output
as "?")
-
Interlocking of NC START
-
Correct program in EDITOR or
delete the complete block and re¬
enter it
-
If
a
large number of "?" appear, it could mean that the whole
memory has been deleted in which case
the battery should be
checked and the
part
program memory reformatted
Effect:
Remedy:
2046
Block
>
120 characters
Scan:
Effect:
Explanation:
During machining in AUTOMATIC
Interlocking of NC START
An "LF" has been corrupted in the
memory,
so that
a block with more
than
1
20 characters has arisen
Insert "LF" without deleting the complete block
Remedy:
2047
Option
not
available
Interlocking of
NC
START
A
function was programmed that is not included in the function
set of
the control
Correct the program, check MD
Effect:
Explanation:
Remedy:
8-18
©
Siemens AG 1990 All
Rights Reserved 6ZB5 410-0EE02
SINUMERIK
805,
SW2 (BA)