Rice Lake IQ PLUS 710 Installation Manual page 18

3.1.3 Front Panel Configuration
The IQ plus 710 indicator can be conÞgured using a series of menus accessed through the indicator front panel
when the indicator is in setup mode. Table 3-1 summarizes the functions of each of the main menus.
Menu
CONFIG Configuration
FORMAT Format
CALIBR Calibration
SERIAL Serial
PROGRM Program
PFORMT Print Format
SETPTS Setpoints
DIG IN Digital Input
ALGOUT Analog Output
VERSION Version
ZERO
Move UP /
Increment Value
Four front panel keys are used as directional keys to navigate through the menus in setup mode (see Figure 3-2).
The ( ) and
UNITS PRINT
( ) move up and down (vertically) to different menu levels. The
GROSS/NET
key for selecting parameter values within the menus. A label over each of these keys identiÞes the direction
provided by the key when navigating through the setup menus.
14 IQ plus 710 Installation Manual
Configure grads, zero tracking, zero range, motion band, overload, tare function, power-up
mode, analog and digital filtering parameters.
Set format of primary and secondary units, decimal format, and display rate.
Calibrate indicator. See Section 4.0 on page 36 for calibration procedures.
Configure EDP and printer serial ports.
Set date and time formats, truck mode, passwords, keyboard locks, regulatory mode, and
initial consecutive number value; enable accumulator; define setpoint and macro prompts, and
program macros.
Set print format used for header, gross, net, truck in/out, setpoint, and EDP format tickets. See
Section 6.0 for more information.
Configure setpoints and batching mode.
Assign digital input functions.
Configure analog output module. Used only if analog output option is installed.
Display installed software version number.
Table 3-1. IQ plus 710 Menu Summary
GROSS
NET
B/G
ENTER Value
Move DOWN /
Decrement Value
SETUP MODE 5-KEY FUNCTIONS
Figure 3-2. Five-Key Keypad Functions in Setup Mode
( ) keys scroll left and right (horizontally) on the same menu level;
Menu Function
TARE UNITS
Units
Move LEFT /
Previous
PRINT
Move RIGHT /
Next
ZERO
key ( ) serves as an Enter
TARE
( ) and