Tools And Test Equipment; Tools Supplied With The Director; Torque Tool And Hex Adapter - HP StorageWorks Director 2/64 Installation Manual

Tools and Test Equipment

This section describes tools and test equipment that may be required to test,
service, and verify operation of the director and attached HAFM appliance. These
tools are either supplied with the director or must be supplied by service
personnel.

Tools Supplied with the Director

The following tools are supplied with the director. Use of the tools may be
required to perform test, installation, service, or verification tasks.
Figure 4: Torque tool and hex adapter
Director 2/64 Installation Guide
Torque tool with hexagonal adapter—The torque tool with 5/32" hexagonal
adapter, as shown in
cards.
Caution: The torque tool supplied with the Director 2/64 is designed to
tighten director logic cards and is set to release at a torque value of six
inch-pounds. Do not use an Allen wrench or torque tool designed for use with
another HP product. Use of the wrong tool may overtighten and damage logic
cards.
Figure 4, is required to remove and replace director logic
Overview
31