Table of Contents
Advertisement
ID
Item
D
DC cable connectors
E
DC lamp power cables
F
Lamp breaker
G
Outlet breaker
H
Power phase indicator lights
I
LPS power inlet
Positioning the projector
Position the projector in relation to the screen.
1. Position the projector at an appropriate throw distance (projector-to-screen distance) and
vertical position. Ideally, center the projector with the screen. If space is limited, aim the
projector slightly off-center. This increases side keystoning, but reduces the horizontal lens
offset required.
Keep the projector lens as perpendicular to the screen as possible, even if significantly above
the screen center. When a particularly short throw distance combines with a wide screen, you
may have to forfeit some aim and stay more perpendicular to the screen. In such cases,
some lens offset can reduce the keystone distortion.
2. If using the Roadie 4K frame (P/N: 129-115108-XX), install the projector using the
instructions provided with the frame.
Roadie 4K35 Quick Start Guide
020-101671-04 Rev. 1 (01-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Description
Locking connectors for DC cables. These connectors are shipped
separately and must be connected by an electrician.
Carries power from the LPS to the projection lamp.
Acts as a power switch, protecting the LPS against over-current
conditions of 50A or more.
Acts as a power switch, protecting the projector electronics against over-
current conditions of 15 A or more.
Indicates the power on each of the three phases.
Supplies power to the LPS. This connection must be wired by an
electrician, according to local regulations.
Installation and Setup
16
Advertisement
Table of Contents
