Configuring Ballast Settings For 200 Vac Operation - Christie Roadie 4K35 Quick Start Manual

Danger! Failure to comply with the following results in death or serious injury.
•
8. Set the three LPS breakers to their on positions.
9. Set the projector breaker, located on the baseplate below the projector AC receptacle, to the
on position.

Configuring ballast settings for 200 VAC operation

Convert the voltage to 200 VAC for the lamp power supply (LPS).
1. Unplug the LPS from power.
2. Remove the front panel using a Phillips screwdriver.
3. Insert the convenience outlet harness (black) wire into the first position on the terminal
block.
Roadie 4K35 Quick Start Guide
020-101671-04 Rev. 1 (01-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
FIRE HAZARD! Do not cross-connect the high current DC cables of the lamp power
supply and the projector's interlock/control cables in a multi-projector installation.
Installation and Setup
19