Connecting To A Computer Or Server; Setting Up Ethernet - Christie Roadie 4K35 Quick Start Manual

High-brightness projection system

Hide thumbs Also See for Roadie 4K35:

Table of Contents

Connecting to a computer or server

Communicate with a remote computer, server, or an existing network using a RJ-45 cable.

The RS232 port located on the MCPU faceplate uses Christie-proprietary protocol and is intended for

Christie accessories or automation controllers only.

For more information, on the serial commands, see the Roadie 4K Serial API Commands Technical

Reference (P/N: 020-101691-XX).

1. Use an RJ-45 cable to connect the Ethernet hub or switch to the Ethernet port, located on the

projector MCPU faceplate.

2. When using the Christie serial protocol over Ethernet, connect to port 3002.

3. For applications or equipment using serial communications, use the Christie-proprietary serial

protocol to communicate with the RS422 port or the RS232 ports on the MCPU faceplate.

Ethernet is setup to obtain an IP address automatically if a DHCP server is on the network. To modify

IP settings, or manually enter an address.

1. On the touch panel controller, tap Menu > Configuration > Ethernet Settings > Modify

IP Settings.

2. Set the network information for the projector

•

To obtain information automatically from the network, tap Automatic.

•

To manually enter the network information, tap Manual and enter the IP Address,

Subnet Mask, and Gateway (optional).

3. Click Ok.

Roadie 4K35 Quick Start Guide

020-101671-04 Rev. 1 (01-2016)

Connecting devices

Table of Contents