2.5.8
Clearing the Memory
In SET-UP, press the MEM button:
• The MEM symbol flashes
• The small display indicates "ALL"
• The main display indicates "cLR"
To clear the entire memory, press the MEM button again for 2 seconds:
• The MEM symbol is displayed without flashing
• The small display indicates "ALL"
• The main display indicates "FrEE"
To clear the contents of a specific OBJ : TEST number:
• Select the number using the
"FrEE" or "OCC" appears on the main display
•
Press the MEM button again for 2 seconds to clear the contents:
• The small display indicates the OBJ : TEST number
• The main display indicates "FrEE"
2.5.9
Communication Rate (RS-232)
In SET-UP, press the PRINT button.
•
• The main display indicates the Communication Rate (e.g. 300, 600, 1200,
2400, 4800, 9600 or Parallel).
• "bAUd" appears on the small display. The value can be changed using
the and buttons.
•
"Parallel" appearing in the display means that the parallel mode has
been selected. This is for printing on a parallel printer via the serial-to-
parallel adapter (RS-232 Centronics).
2.5.10 Default Device Configuration
In SET-UP, press the
• "SEt" appears in the small display.
• "DFLt" (flashing) appears in the main display.
Press START to select the default configuration settings (see the previous table).
20
0.561.8187
and
button three times:
www.
.com
buttons
Megohmmeter Models 5050/5060
information@itm.