Table of Contents
Advertisement
Second Function - MR
The MR function allows a recall of any saved data from memory, regardless of the
position of the rotary selector switch.
• When the button is pressed, the MR symbol is displayed. The small dis-
play indicates the last OBJ : TEST number to be assigned (e.g. 02 :11).
• 02 "11" flashes opposite the TEST symbol. Use the
select the desired OBJ : TEST number.
• If a new OBJ is selected, TEST is automatically set to the maximum
stored number. At this stage, it is possible to review the entire memory
with the
to the selected OBJ : TEST number are displayed on the main display.
Use the R-DAR-PI-DD button to scroll through them.
• The V/TIME button gives access to the date /time /V/OBJ-TEST number
for each result.
• If the recording selected by the OBJ : TEST number corresponds to a
time-controlled test, the R(t) values can be accessed by pressing the
R(t) button. The small display changes and indicates min:sec (time of 1st
sample) and the symbol
the other samples with the
To exit from R(t) mode and return to the normal memory recall mode (OBJ : TEST),
press R(t) or R-DAR-PI-DD again.
To exit the MR function, press MR button once again or turn the selector switch.
6.3 Printing Measured Values
(PRINT/PRINT MEM Button - Model 5060)
If you use a serial printer, choose the appropriate communication speed (baud
rate) in the SET-UP menu, between 300 - 9600 baud, then program the printer to
the format run by the instrument (see § 6.1).
There are two printing modes possible:
• Instantaneous printing of measurement (PRINT)
• Printing of recorded data (PRINT memory)
NOTE: If the data transmission to the printer is successful, the COM symbol
flashes once on the screen. If a problem has occurred, the COM symbol
remains on the LCD screen without flashing.
38
0.561.8187
and
buttons, since the measurement values corresponding
flashes on the screen. You can scroll through
button.
www.
Megohmmeter Models 5050/5060
.com
and
buttons to
information@itm.
Advertisement
Table of Contents
