Smooth Button; Up/Down Button - AEMC 5050 User Manual

• Press the Right Arrow Key again to move to the Resistance Value Set
• When finished programming the alarm settings, place the rotary switch to
• Before initiating a test, press the Yellow 2
• Next, press the round yellow Start/Stop button to begin the test. The Alarm
2.5.5
First Function -
Selects the desired parameter to be modified - the selected parameter flashes.
The flashing parameter is modified using the
Second Function - SMOOTH
Activates a digital filter for insulation measurement. It only has an effect on the
displayed values (which are smoothed) and not the actual measurements.
For example, this function is useful when the displayed insulation values are highly
unstable, brought about due to a capacitive component in the tested element.
2.5.6
Changes the flashing parameters displayed, or views R(t) values (see § 2.5.3).
As a general rule, two figures (day, month, hour, min., sec., and OBJ:TEST) flash.
The  and  functions have a "follow-on" mode. (e.g. as soon as the high or low
program limit is reached, the parameter to be modified switches automatically to
the following low or high limit.)
Megohmmeter Models 5050/5060
0.561.8187
Point Selection. You can change this value digit by digit using the Up
Arrow / Left Arrow combination working from the highest to lowest digit.
the desired test function.
to activate the Alarm Notification. The word "ALARM" will appear in the
lower left side of the display.
symbol will flash and the buzzer will sound continuously if the Alarm set
point is tripped.
NOTE: If the rotary switch is turned off prior to the next test, the alarm notification
will be deactivated. You will need to press the Yellow 2
button to activate the Alarm Notification when you turn the unit back on before
starting the next test, if alarm notification is desired.

/ Smooth Button

Button
www.
button and the Alarm button
nd
button (see § 2.5.6).
.com
button and the Alarm
nd
information@itm.
17