Table of Contents
Advertisement
2.3 Bargraph
• Active during insulation measurement (0.1MΩ to 1TΩ).
• Indicates the battery charge at start-up.
• Indicates free memory space - one segment representing approximately
100 groups of saved values, with each group holding approximately 50
recordings (1 OBJ and 1 TEST).
2.4 Symbols
MEM/MR: Memory address (5060) - indicates the memory operation.
OBJ:TEST: Memory address (5060) - the number is displayed on the small digital
display.
COM: Flashes on the screen when data is transmitted to the serial interface (5060)
or remains permanently displayed if there is a problem during transfer.
DAR/PI/DD: Indicates the mode chosen before insulation measurement or the
results of these measurements.
Dangerous voltage generated; V > 120V.
External voltage present, symbol is activated after pressing START, if V
> 25V
Activation of "time-controlled test" mode or clock adjustment when in
SET-UP (5060).
(Yellow button) Selects the second (bottom) function of a button.
Flashes if the battery voltage is low, indicating that the battery should
be recharged (see § 8.1). The voltage is displayed on the small display
for 2 seconds when the instrument is turned on. The main display
indicates "bat" when the test is carried on.
Warning buzzer is activated.
Indicates that the automatic switch-off function has been deactivated.
SMOOTH: Smooths the insulation measurements displayed.
REMOTE: Remote control via an interface (5060). In this mode, all the buttons
FUSE -G-: Flashes if the "G" input fuse is defective.
10
0.561.8187
± 3V or > 35V
AC
and the rotary switch on the instrument are non-functional, except for
the OFF position.
www.
.
DC
.com
Megohmmeter Models 5050/5060
information@itm.
Advertisement
Table of Contents
