Stopping A Recording Session; Downloading Recorded Data; Erasing Data From Memory - AEMC SIMPLE LOGGER II User Manual

4.4.2

Stopping a Recording Session

1. Press and hold the PRESS button. When the STOP (ORANGE) LED
lights up, release the button.
2. The GREEN LED will change from a double-blink to a single-blink,
indicating STANDBY mode.
The data will be retained, even if the instrument is turned OFF. The recorded
data is stored in Flash memory, meaning that it will be maintained even
in the absence of batteries. The recorded data may be downloaded to a
computer.
4.5

Downloading Recorded Data

Recorded measurements stored in the instrument are transferred to a
database on a hard-disk via the download command in the Simple Logger
II Control Panel. For complete instructions on downloading data, see the
Downloading Recorded Instrument Data section inside the DataView
user manual that shipped with the instrument.
4.6

Erasing Data from Memory

Erasing data from the instrument's memory can only be performed while
in the STANDBY mode.
There are two ways to erase the memory:
Erasing the Memory using the PRESS Button:
1. Press and hold the PRESS button. When the ERASE (RED) LED
lights up, release the button.
This will arm the instrument for an erase operation (when not in record
mode). While armed to erase memory, the RED LED will blink at a fast
rate for a period of five seconds.
2. Press the PRESS button for another 0.5 seconds to complete the
erase operation.
NOTE: If the button is not pressed within five seconds of arming, the erase
operation will automatically disarm and memory will be maintained. For this
reason, if you do not intend to erase memory, simply wait until the RED LED
stops blinking at the fast rate.
14
®
Simple Logger II Model L261
®
®