Table of Contents
Advertisement
Use only factory specified replacement parts. AEMC
for any accident, incident, or malfunction following a repair done other than by its
service center or by an approved repair center.
8.1 Recharging the Battery
If the
symbol is flashing, the battery needs to be recharged.
Connect the instrument to the 120V
starts automatically).
•
bAt on the small display and CHrG or chAr on the main display, signi-
fies fast charging in progress.
•
bAt on the small display and CHrG flashing on the main display, signi-
fies slow charging (starts off with fast charge, temperature conditions
permitting).
•
bAt on the small display and FULL on the main display, signifies that
charging is over.
If the instrument is started up and the battery voltage is >8V, then the normal use
of the device is permitted.
NOTE: The battery should only be changed by an authorized repair facility recog-
nized by AEMC
Changing the battery causes data to be lost from the memory.
Press the MEM /MR button ("OFF" is displayed).
Proceed with a total clearing of memory in SET-UP (see § 2.5.7) so the MEM /MR
functions can be used again.
54
0.561.8187
CHAPTER 8
MAINTENANCE
AC
Instruments.
®
www.
will not be held responsible
®
power cord via the connector (charging
Megohmmeter Models 5050/5060
.com
information@itm.
Advertisement
Table of Contents
