Table of Contents
Advertisement
7.3.1
To configure the instrument, perform the following steps.
1. Click the Configure Instrument button. A dialog box will open, allowing you
to select the Communication Rate and the Serial Port for communicating with
the Model 5060.
2. Make sure that the serial port displayed in the dialog box matches the port you
plugged the serial cable into. If the correct serial port is not selected, click on
the drop down arrow and select the proper one.
3. The Communication Rate will default to 9600 and should be acceptable to
any computer. This is also the default rate for the Model 5060. You may select
a different rate by clicking on the Communication Rate drop-down menu and
selecting from the available values.
4. Once the proper communication parameters have been specified click on the
OK button.
Megohmmeter Models 5050/5060
0.561.8187
Configuring the Instrument
www.
Figure 7-4
Figure 7-5
.com
information@itm.
47
Advertisement
Table of Contents
