Stormshield SN series Configuration Manual page 76

To the right of it, there are two buttons and a checkbox, which allow modifying certain actions:
Launch
Clear display
Raw output
Most commands displayed in the list at the top of the page involve others. To view all these
commands, proceed as follows:
Enter the command of your choice in the text entry zone.
Click on "Launch".
Depending on the command you have selected, the list will display the additional commands
included in it.
Example
If you enter the CONFIG command, all commands relating to it will appear on the screen.
To use one of these commands, enter "CONFIG" in the data entry zone, followed by a space and
the desired command, such as: "CONFIG HA".
Page 76/448
This button allows launching the command that was entered manually.
The command will also be launched when the user presses "Enter".
NOTE
In the field for editing commands, you can browse through the various
commands that have already been launched, using the Up/Down buttons.
Command history is stored and re-used each time the web application is
launched.
This button allows erasing the list of commands displayed above it (cf "List of
commands"). To view them again, enter the HELP command in the data entry zone and
click on "Launch".
If this option is selected, the launch of the command will display the line of code in its
raw form between markers.
NOTE
SNS - USER CONFIGURATION MANUAL V.3
sns-en-user_configuration_manual-v3 - Copyright © Stormshield 2016
CLI CONSOLE