Stormshield SN series Configuration Manual page 127

Statistics on the use of rules
In the active policy, each activated filter and NAT rule displays a counter that shows the number
of times the rule has been used. When scrolling over the icon with a mouse, a tooltip will indicate
the exact number of times the rule has been executed. The 4 levels of use correspond to the
following values, according to the percentage on the counter of the rule most frequently used:
To obtain a new indicator, clicking on "Reset rule statistics" will start a new count. This counter will
be reinitialized if:
One of the parameters in the rule has been modified (except for comments),
l
Another policy has been enabled,
l
The firewall has been rebooted.
l
If no icons are displayed, this means that the information is unavailable.
State
This column shows the status of the rule: On
doing this once, you will enable the filter rule. Repeat the operation to disable it.
Action
This zone refers to the action applied to the packet that meets the selection criteria of the filter
rule. To define the various parameters of the action, double- click in the column. A window
containing the following elements will appear:
"General" tab
General
Page 127/448
0%
from 0 to 2%
from 2 to 20% (from 2 to 100% if the counter is lower than 10 000)
from 20 to 100 %, with a minimum of 10 000 times (otherwise the previous
level will be displayed)
/Off . Double-click on it to change its status. By
sns-en-user_configuration_manual-v3 - Copyright © Stormshield 2016
SNS - USER CONFIGURATION MANUAL V.3
FILTERING AND NAT