Report Configuration; General" Menu; Table Of Reports And History Graphs; List Of Reports" Tab - Stormshield SN series Configuration Manual

REPORT CONFIGURATION

These reports are compiled based on logs saved on the firewall. These logs are analyzed and the
most frequently recurring values are stored within a database. The top 10 and 11
corresponding to "Others" is therefore based on these values.
Data is refreshed every minute (5 minutes for U30/U70, U30S/U70S and SN200/SN300 models
without SD cards and SN150). The refreshment includes a calculation of a new Top 50 over the
last few hours and days in order to better represent the recurrent values and to avoid overloading
the database.
Data stored on SD cards can be read by other platforms equipped with an SQLite engine.
Reports are based on all traffic processed by the firewall, meaning for connections passing
through all interfaces, internal and external.
Even though the generation of reports does not have priority over other treatments, the
number of reports enabled or the type of traffic may have a real impact on the performance
of the appliance (Dashboard: CPU and memory).
This module also allows enabling history graphs available in the Monitoring module.
This screen is divided into 2 sections:
Top: the options that make it possible to enable report management and/or history graphs.
l
Bottom: table listing all reports and history graphs that may be selected in two tabs.
l
Certain reports or history graphs require some features (such as antivirus, vulnerability
management or authentication) to be enabled. Please refer to the monitoring module to find
out which features are required and the possible interactions.

"General" menu

Enable reports
Enable history graphs This option allows enabling history graphs that can be viewed in the Monitoring

Table of reports and history graphs

"List of reports" tab

The table sets out the following columns:
Status
Page 302/448
WARNING
NOTE
This option makes it possible to enable reports calculated based on logs stored on the
hard disk or on an SD card (S series firewalls).
module.
Allows enabling/disabling the report in question.
SNS - USER CONFIGURATION MANUAL V.3
sns-en-user_configuration_manual-v3 - Copyright © Stormshield 2016
REPORT CONFIGURATION
th
value