Ip Protocol; Group - Stormshield SN series Configuration Manual

Port range
From
Up to
TCP/UDP
Comments

IP protocol

Name of the object
Protocol number
Comments

Group

In this screen, you will be able to aggregate your objects according to your network topology, for
example.
Name of the object
Comments
Edit this group
Objects in this group
Page 242/448
By selecting this option, you will assign a port range to the selected service and
enable the two checkboxes below it.
If the Port range checkbox has been selected, this field will be enabled. It corresponds
to the first port included in the selected port range.
If the Port range checkbox has been selected, this field will be enabled. It corresponds
to the last port included in the selected port range.
Select the IP protocol that your service uses:
TCP: Transmission Control Protocol. Transport protocol operating in connected mode
and made up of three phases: establishment of the connection, data transfer, end of
the connection.
UDP: User Datagram Protocol. This protocol allows transferring data simply between
two entities, each of them having been defined by an IP address and a port number.
TCP or UDP: The selected service can use any IP protocol.
Description of the selected port or port range.
Name of the selected IP protocol. This field is grayed out and cannot be modified.
Number associated with the selected IP protocol and provided by the IANA (Internet
Assigned Numbers Authority).
Description of the selected IP protocol.
Name given to the object group during its creation.
Objects in "read only" mode will be grayed out and cannot be modified.
Description of the object group.
This button contains a dialog box for adding objects to the group.
Two columns will appear:
The left column contains the list of all the network objects that you may add to your
group. The right column contains the objects that are already in the group.
To add an object to the group, you need to move it from one column to the other:
Select the item(s) to add.
Click on this arrow . The object will move to the right column and become a part
of your group (at the top of the list).
To remove an object from the group, select it in the right column and click on this arrow
.
NOTE
By clicking on the button "Edit this group", you will be able to change the name
of the group and add comments to it and also search for objects and include
new objects in the group.
The network objects in your group will be shown in a table.
To add or modify objects, refer to the previous field.
SNS - USER CONFIGURATION MANUAL V.3
sns-en-user_configuration_manual-v3 - Copyright © Stormshield 2016
NETWORK OBJECTS