System Alarms List - Stormshield SN series Configuration Manual

Message (language
depends on the
firewall language)
Open help
Configure
When you modify the alarm level of an event, don't forget to click on "Apply" at the bottom
of the page, in order to confirm your action.

System alarms list

ID Name
1 System shutdown
2 Authentication failed for
3 Connection terminated for
4 20% left in log file
5 Connection established for
6 IPsec phase 1 failed
7 IPsec phase 2 failed
8 IPsec pre-shared key not found
9 Firewall startup
10 HA: Mode change
11 HA: Peer lost
12 Invalid CRL
13 Invalid Certificate
14 log partition has changed
15 System error
16 User denied in IPSEC negotiation
Page 345/448
This field shows the name of the system event and its characteristics (cannot be
edited).
NOTE
By clicking on the arrow on the right side of the column header, you can invert
the order in which events appear.
When you select an event from the list by clicking on it, a "Show help" link appears.
Clicking on this link will take you to the Stormshield Network knowledge base,
providing more details on the information relating to the event.
Send an e-mail: an e-mail will be sent when this alarm is raised (cf. module E-mail
alerts) with the following conditions:
Number of alarms before sending : minimum number of alarms required
l
before an e-mail is sent, during the period defined hereafter.
During the period of (seconds): period in seconds during which alarms have
l
been raised, before an e-mail is sent.
Quarantine host: the packet that caused the alarm will be blocked with the following
parameters. To remove a packet from quarantine, use Stormshield Network Realtime
Monitor.
for a period of (minutes): duration of the quarantine
l
GENERAL NOTE
SNS - USER CONFIGURATION MANUAL V.3
sns-en-user_configuration_manual-v3 - Copyright © Stormshield 2016
SYSTEM EVENTS