Creating A Bridge - Stormshield SN series Configuration Manual

Configuration with DHCPv6 server
The DHCPv6 server
assigns addresses
(Managed)
The DHCPv6 server
delivers additional
options (Other config)
Advanced properties
DNS settings
Domain name
Primary DNS server
Secondary DNS server IP address of the secondary DNS server. If this field is blank, the address sent will be
Announced prefixes
Even though it is recommended that the announced prefix be the same as the interface's prefix,
in the event the interface specifies several, this field will indicate the prefix to use.
Prefixes
Autonomous
On link
Comments
Optional parameters
Certain specific parameters for router advertisements can be configured in CLI, such as the
maximum size of a packet sent (MTU) over the link, the validity duration of the prefix(es) used
over the link or the field Router Lifetime.
For more details and the possible values of these parameters, please refer to the guide "CLI
serverd command reference – V1.0" available in your client area.

Creating a bridge

Address range
IPv4 address
Page 376/448
The advertisement indicates that the IPv6 addresses solicited will be distributed by
the DHCPv6 service enabled on the firewall (Network> DHCP).
This service is implemented by the firewall or a relay that is directly connected (local
link).
The advertisement indicates that other auto-configuration parameters such as the
addresses of DNS servers or other types of servers, will be delivered by the DHCPv6
server (firewall or relay) that is directly connected (local link).
Default domain name to contact a queried server that does not have a domain.
IP address of the primary DNS server. If this field is blank, the address sent will be the
address used by the firewall (System > Configuration)
the address used by the firewall (System > Configuration)
Prefix to announce to hosts
Instruction to use stateless address auto-configuration (SLAAC): if this option has
been selected, the host will then create one or several IPv6 addresses based on the
prefix(es) advertised and its interface ID (random and/or based on the MAC address.
This option specifies to the host that all hosts with the same prefix may be contacted
directly, without going through the router.
NOTE
In IPv4, such information was deduced from the network mask.
Allows adding comments for the announced prefix.
When this option is selected, the bridge will have an IPv4 address. If this address is
static, this has to be indicated in the field below the checkbox along with its network
mask. By default, a dynamic address will be assigned to it via DHCP.
SNS - USER CONFIGURATION MANUAL V.3
sns-en-user_configuration_manual-v3 - Copyright © Stormshield 2016
IPV6 SUPPORT