Connecting To Network And Devices - Grandstream Networks GVC3200 User Manual

CONNECTING TO NETWORK AND DEVICES

GVC3200/GVC3202 supports a variety of network connections (Ethernet, Wi-Fi) and device connections,
including USB, SD card and Bluetooth devices. When the GVC3200/GVC3202 boots up for the first time,
a setup wizard will guide the users to pair and connect the remote control to GVC3200/GVC3202 and get
started with the basic configurations.
ETHERNET
If the user would like to use Ethernet connection for network access, please plug the Ethernet cable into
the LAN port on the back of GVC3200/GVC3202. Ethernet connection is turned on as DHCP by default.
To configure Ethernet settings on GVC3200/GVC3202:
1. Plug the Ethernet cable into the LAN port on the back of GVC3200/GVC3202.
2. Go to LCD menu->Settings->Network->Ethernet->IPv4 Settings.
3. Tap on "Address Type" to select DHCP, Static IP or PPPoE as the address type.
 For DHCP, save the setting and GVC3200/GVC3202 should be able to get IP address from the
DHCP server in the network.
 For static IP, enter IP Address, Subnet Mask, Default Gateway, DNS Server and Alternative DNS
server for GVC3200/GVC3202 to correctly connect to the network.
 For PPPoE, enter PPPoE account ID and password so that GVC3200/GVC3202 can get IP
address from the PPPoE server.
WI-FI (GVC3200 ONLY)
Wi-Fi is supported and built-in on GVC3200 by default. On the LCD display, go to Settings->Network->
Wi-Fi to turn on and configure Wi-Fi.
Firmware Version 1.0.1.65 GVC3200/GVC3202 User Guide Page 42 of 145