Connecting To Network And Devices; Ethernet; Bluetooth; Turning Bluetooth On / Off - Grandstream Networks GVC3202 User Manual

CONNECTING TO NETWORK AND DEVICES

GVC3202 supports a variety of network connections (Ethernet) and device connections, including USB,
SD card and Bluetooth devices. When the GVC3202 boots up for the first time, a setup wizard will guide
the users to pair and connect the remote control to GVC3202 and get started with the basic configurations.

ETHERNET

If the user would like to use Ethernet connection for network access, please plug the Ethernet cable into
the LAN port on the back of GVC3202. Ethernet connection is turned on as DHCP by default.
To configure Ethernet settings on GVC3202:
1. Plug the Ethernet cable into the LAN port on the back of GVC3202.
2. Go to LCD menu->Settings->Network->Ethernet->IPv4 Settings.
3. Tap on "Address Type" to select DHCP, Static IP or PPPoE as the address type.
 For DHCP, save the setting and GVC3202 should be able to get IP address from the DHCP
server in the network.
 For static IP, enter IP Address, Subnet Mask, Default Gateway, DNS Server and Alternative DNS
server for GVC3202 to correctly connect to the network.
 For PPPoE, enter PPPoE account ID and password so that GVC3202 can get IP address from
the PPPoE server.

BLUETOOTH

On GVC3202, Bluetooth is enabled by default. Users could connect Bluetooth by remote control, send or
receive files to cellphone, or use Bluetooth speaker and etc on GVC3202.

TURNING BLUETOOTH ON / OFF

1. On the LCD display device, go to Settings->Network->Bluetooth.
2. Tap on the green switch on the top row to turn on/off Bluetooth. Please note the Bluetooth needs to
be turned on, in order to use the remote control.
Firmware Version 1.0.0.X GVC3202 User Guide Page 33 of 117