Racelogic PerformanceBox Manual page 29

Racelogic Ltd Power Mode
Begin to accelerate, and press OK. Continue to accelerate to the top of the engine rev range.
At the top of the rev range, disengage the clutch and put the gearbox into neutral. Once
deceleration has begun the screen will display the recording information:
Let the vehicle coast down to a speed a long way below the speed at which maximum power is
likely to occur, then accelerate briefly to finish the run:
Press OK to save the losses; pressing RESET will cancel the recorded losses so that you can start
the process again. Losses are permanently saved, but you should generally carry this out on the
same piece of road in the same direction as your acceleration runs. Note any small gradient can
have a large effect on the measurement.
If you have not carried out any power tests at this point then accessing the Power Run screen will
simply display the priming instructions. If you have already carried out power runs the results will
now be displayed as output from the flywheel rather than the wheels. Any further power runs will
display the results at the flywheel, until the RESET button is pressed when in the Losses Run
screen.
Pressing the RESET button when in the Power Run screen will clear the result in order for a new
run to commence
.
02/05/2014 Page 29