Editing A Performance Mode Test Range - Racelogic PerformanceBox Manual

Racelogic Ltd
8. After doing a number of runs you can view your best 0-60 time by scrolling to the BEST
screen.
9. If you have your SD card inserted then your run data will be stored.
Please note, to record a results file, you must accelerate over at least 30 Km/H.

Editing a Performance mode Test Range

You can configure the minimum and maximum speeds of two of the acceleration ranges, the 0-
100-0 range, the deceleration ranges, and one of the distance ranges, to give an array of useful
tests.
If you wish to change the speed range over which performance is measured, press the MENU
button from any of the performance mode screens and select the range you wish to change from
the 'Performance Menu' and press OK
Example: Editing ACCEL RANGE 1
1. Highlight 'ACCEL RANGE 1' and press OK
2. The following screen will appear with the start speed of ACCEL RANGE 1 highlighted:
3. Whilst the START speed is highlighted use the
4. Press OK and repeat this procedure for the END speed:
02/05/2014
PERFORMANCE MENU
UNITS
WRITE RESULTS FILE
ACCEL RANGE 1
ACCEL RANGE 2
0-100-0 RANGE
▲▼
Page 14
Performance Mode
buttons to change the speed.