Changing The Units Of Measurement; Satellite Reception; Searching For Satellites At Power Up - Racelogic PerformanceBox Manual

Racelogic Ltd

Changing the Units of Measurement

1. Press the MENU button from any of the Display Modes.
2. Highlight UNITS and press OK.
3. Highlight SPEED and press OK.
4. Highlight KMH or MPH and then press OK to tick that selection.
5. Highlight EXIT and press OK.
To change the Distance units from metres to feet, follow the same procedure but highlight
DISTANCE and press OK.

Satellite Reception

PerformanceBox calculates all of its logged data from the information it receives from GPS
satellites and relies on being able to get a good lock to produce this data. So it is imperative that
PerformanceBox (or optional external antenna) is placed in the best possible position for a clear
view of the sky.
If you are using an external antenna, ensure that it is connected before you power up
PerformanceBox.
The location that you drive in can also affect data quality, if you drive in a very built up area or an
area with overhanging trees then the signal quality can degrade. If the satellite reception does drop
out in use, you will see either of the following symbols:
1.
2.
3.

Searching for satellites at power up

Whilst the PerformanceBox is acquiring satellites it will flash the image of a satellite, the location of
the flashing image depends on the screen you are in.
02/05/2014 Page 11
Using PerformanceBox