Racelogic PerformanceBox Quick Start Manual

Register your PerformanceBox to activate all functions:
www.vboxmotorsport.co.uk/register
Quick Start Guide

Installation

For best satellite reception, ensure your PerformanceBox
is fixed low down in the centre of the windscreen. The
first time the unit is used, it will need to be left for 10-15
minutes to fully acquire satellites. After this, it will usually
take 1-2 minutes to acquire satellites.
Press or
to scroll between
tests
Either button
sets lap start/
finish line

Performance Tests

Ensure the unit is in Performance Mode. In this
mode, you can select a number of user-configurable
tests, including 0-60, 0-100, 0-100-0, ¼ mile etc.
Before starting an acceleration test, ensure the
vehicle is absolutely stationary.
Once a test has been performed and the vehicle has
stopped, you can immediately start another test. You
do not need to press any buttons between tests of the
same type. For best results, perform tests away from
buildings and trees.
On the SD card:
Performance Tools
software
Circuit Tools software
User manual
Lap Timing - Setting a
Start/Finish line
Ensure the unit is in Lap
Timing mode. Press
button while driving over
the point you wish to define as
your start/finish line.
or