Safety Principles For The; Three-Point Hitch Manipulation; Procedure Of Attaching Machines To The Three-Point Hitch - Zetor 86 41 forterra turbo Operator's Manual

SAFETY PRINCIPLES FOR THE

THREE-POINT HITCH MANIPULATION

The individuals who are not
charged with the manipulation of
the tractor additional equipment
may not keep to the space be-
tween the tractor and the ma-
chine (implement) to be con-
nected - (A). Do not park the
tractor with the attached imple-
ments lifted - (B).
HITCHES
F_02_79

PROCEDURE OF ATTACHING MACHINES TO THE THREE-POINT HITCH

The L.H. lifting tie rod (1) is adjustable after uncoupling the upper end from the lifting
arm pin and it serves for the rough setting of the position. The fine setting is then
performed with turning the tube of the R.H. lifting tie rod (2) with a handle.
The tie rod ends can be vertically readjusted with respect to each other through 200
mm as maximum. A free connection of the agricultural implement to the tractor and
the mutual skewing around the longitudinal axis is possible after replacing the pin (3)
to the lower hole (4). Both ends of the tie rods can, in this case, move vertically in-
dependently on each other through 100 mm. The transversal guiding of the imple-
ment is ensured with limiting tie rods (5). The ends of the lower tie rods with the im-
plement of the category II connected may swing from the middle position through
100 mm to both sides (in a reinforced three-point hitch they can swing through 125
mm). The side swing of the tie rods may be excluded by blocking the limiting tie
rods.
139
F193