General Principles Of Running In A New Tractor In The Course Of The First 100 Operating Hours; In The Course Of The First 10 Hours - Zetor 86 41 forterra turbo Operator's Manual

GENERAL PRINCIPLES OF RUNNING
IN A NEW TRACTOR IN THE COURSE
OF THE FIRST 100 OPERATING
HOURS
In the course of the first operating hours:
- Apply the normal load to the engine
- Avoid operation at partial engine load
- Avoid excessive idle run
- Check frequently oil for level in the
engine (in the course of this period a
higher oil consumption is typical)
- Check the screwed joints mainly of the
tractor supporting parts for proper
tightening
- Remedy the faults detected immedi-
ately for avoiding the subsequent
damage or threat to the safety of op-
eration
TRACTOR RUNNING IN
- Apply the same procedure after gen-
eral tractor repair, too.
86
F_02_48
IN THE COURSE OF THE FIRST
10 HOURS
- Perform the running-in process in
transport conditions
- Tighten the front and rear wheel fixing
nuts including the bead / rim joint with
the prescribed torque.
F_02_49