Setting Up The Foot Brake; Setting-Up The Parking Brake - Zetor 86 41 forterra turbo Operator's Manual

SETTING UP THE FOOT BRAKE

Before setting up the foot brake, the lever of the hand brake
must be in the brake-released position and a clearance must
be between the nut (1) and the pin (2) in the lever of the disk
brake (3). In casse of detecting zero clearance, loosen the nut
(1) moderately. Lift a bit the rear wheels and make the assis-
tant turn one of them by hand. Simultaneously tighten the ad-
justing nut (4) until the wheel cannot be turned. Do not tighten
more. Then loosen the adjusting nut through 5/6 turn (5 nut
facets) and revise the wheel turning.
After that basic adjustment, check the food brake for proper
operation to be sure that both the wheels have the same
braking effect. If it is not so, then at the side that shows more
braking effect, loosen the adjusting (4) through the required
value.
SETTING-UP OPERATIONS
F_02_139

SETTING-UP THE PARKING BRAKE

The parking brake shall be set up after the adjustment of the
foot brake. The parking brake lever shall be placed in the
brake-released position. During the setting-up, place the self-
locking nut (1) of the parking brake tie rod into contact with the
pin (2) in the lever of the disk brake (3).
After this basic setting-up, check the parking brake for proper
function to be sure that both wheels show the same braking
effect. If not so, loosen the adjusting nut (1) adequately at the
side of higher braking effect.
194
F_02_138