Installing The Shipping Brace Assembly (Optional) - Oracle SPARC T7-4 Installation Manual

a.
b.
If the server is not already installed, install the server.
■
See
Related Information
"CMA Kit Overview" on page 42
■
"Determine Correct Rackmount Hardware" on page 35
■

Installing the Shipping Brace Assembly (Optional)

This shipping brace assembly is included in the shipping kit. Use the shipping brace assembly if
you are installing the server into an equipment rack that will be shipped to another location.
Note -
holes. If you are installing the server into a rack with round mounting holes, see
Correct Rackmount Hardware" on page
"Determine Correct Shipping Brace Fasteners" on page 47
■
"Install the Top Rear Shipping Braces" on page 47
■
"Install the Bottom Rear Shipping Brace" on page 49
■
Related Information
"Rack Compatibility" on page 30
■
"Determine Correct Rackmount Hardware" on page 35
■
"Mark the Rackmounting Location" on page 36
■
"Install the Server" on page 39
■
At the front of the server, push the server back until it touches the rails.
Reinstall the four faceplate screws, two for each side.
"Install the Server" on page
These procedures describe how to install the server into a rack with square mounting
Installing the Shipping Brace Assembly (Optional)
39.
35.
"Determine
Installing the Server 45