Determine Correct Rackmount Hardware - Oracle SPARC T8-4 Installation Manual

Determine Correct Rackmount Hardware

Ensure that the rack is stabilized.
1.
See "Stabilize the Rack" on page
2. Determine the hardware needed for your rack installation.
Rack Type
Square hole
Round hole (10-32) with corner bezel
Round hole (M6) with corner bezel
Round hole (10-32) inside installation
Round hole (M6) inside installation
Some of the fastener bags that are included in the kit are not required to install this
Note -
server.
3. Mark the rackmounting location.
See "Mark the Rackmounting Location" on page
Related Information
"Rack Compatibility" on page 30
■
"Installing the Rackmount Kit" on page 33
■
"Mark the Rackmounting Location" on page 36
■
"Install the Shelf Rails" on page 37
■
32.
Fastener Bags Required
SCREW, SEMS, M6 X 16
CAGE NUTS, M6
SCREW, SEMS, 10-32 X 10
SCREW, FLAT HEAD, M4 X 10
SCREW, SEMS, M6 X 12
SCREW, FLAT HEAD, M4 X 10
SCREW, SHOULDER, 10-32
SCREW, FLAT HEAD, M4 X 10
SCREW, SEMS, M6 X 12
SCREW, FLAT HEAD, M4 X 10
36.
Determine Correct Rackmount Hardware
Installing the Server 35