Wiring Process Peripherals; General; Fitting Peripheral Cable - Siemens SICAM RTU User Manual

Installation
1.8

Wiring Process Peripherals

1.8.1

General

The process peripherals are connected with the system by means of prefabricated peripheral
cables.
1.8.2

Fitting Peripheral Cable

Caution
The peripheral modules must NOT be installed in the board rack during the fitting of the associated pe-
ripheral cable.
The fitting is carried out by engaging the peripheral cable in the seating frame.
Proceed as follows:
·
Insert the peripheral cable into the board rack from below, until the point of the grip flap is
fixed between profile rail and seating frame
wall bracket serves as a guide during installation.
74
Designation
CM-2890 Periphery cable Crimp 5 m
100 pins
Profile rail
Seating frame
1
Item-Number/MLFB
TC2-890
6MF13131CJ000AA0
•
; In the case of wall mounting a plate on the
Point of
grip flap
Guide plate
of rear cover
SICAM RTUs, SICAM AK 3 User Manual
Edition 07.2016, DC2-028-2.03