Removal - Siemens SICAM RTU User Manual

Installation
·
Connect/put on grounding strap and remove front panel
·
Place the module in the guide bracket of the desired slot • and push it carefully up to the
connectors located at the bottom ‚.
·
Then apply the same pressure at both unlocking blocks ƒ in order to connect the module
with backplane (and peripheral cable).
1
1
1.3.3

Removal

Caution
When removing the master control element, all the non-autonomous modules fail (processing and com-
munication element, peripheral element).
For the removal of a module, you will need the unlocking tool TA2-105. This is included in the
scope of supply of every board rack and must be inserted in the bracket provided on the board
rack during installation.
Proceed as follows:
·
Connect/put on grounding strap and remove front panel
·
Position the unlocking tool between module and profile rail
·
Loosen the plug-in connector by pushing the unlocking clip upwards
·
Grasp the module at the unlocking blocks and withdraw it from the board rack
38
Guide bracket
2
2
Guide bracket
Unlocking block
3
3
Unlocking block
•
‚
, or downwards
SICAM RTUs, SICAM AK 3 User Manual
Edition 07.2016, DC2-028-2.03
‚
.
ƒ