Install Power Supply; Installing First Power Supply - Siemens SICAM RTU User Manual

Installation
Board Rack CM-2846 and CM-2843
PS-2 6 3 x CP-2 0 1 6 DI-2 1 1 0 DO-2 2 1 0 AI-2 3 0 0
SICAM AK
PS-2 6 3 x CP-2 0 1 6 DI-2 1 1 0 DO-2 2 1 0 AI-2 3 0 0
SICAM AK
1.7.3

Install Power Supply

The power supplies are slotted into the compartments provided from the front. The cabling is
carried out from the front of the board rack.
Note:
All SICAM AK 3 board racks can be equipped with a first power supply on the left side and a second (re-
dundant) powers supply on the right side. The installation procedure is equal for all board racks. Thus it is
shown only exemplary with a CM-2844 board rack.
1.7.3.1

Installing First Power Supply

The first power supply is installed in the left slot. It needs to be pushed into the compartment
• and fastened with screws ‚. Then the wiring can be carried out. Please refer also to sec-
tion 1.7.4, Wiring of the Power Supply
Slot for
st
1 power supply
Note:
In this case it is possible to install another CP-2019 or a peripheral element in slot 9.
72
In the basic configuration the board rack is fitted with one power
supply.
DI-2 1 1 0 CP-2 0 1 9 AI-2 3 0 1 DI-2 1 1 0 AI-2 3 0 1 DI-2 1 1 0 DI-2 1 1 0 DO -2 2 1 0 AI-2 3 0 0 AI - 2 3 0 1 DI-2 1 1 0
This is installed in the left slot.
A second power supply can be used for redundancy.
This is installed in the right slot.
DI-2 1 1 0 CP-2 0 1 9 AI-2 3 0 1 DI-2 1 1 0 AI-2 3 0 1 DI-2 1 1 0 C P-2 0 1 9 DI-2 1 1 0 D O-2 2 1 0 AI-2 3 0 0 AI-2 3 0 1 DI-2 1 1 0 PS-2 6 3 x
SI CAM AK
2
PS-263x
SICAM AK
1
2
SICAM RTUs, SICAM AK 3 User Manual
Edition 07.2016, DC2-028-2.03