Head Lamps; Lighting System; Pre-Aiming Instructions - Hyundai trajet Shop Manual

BE -66
HEAD LAMPS
LIGHTING SYSTEM
ETHA2900
PREmAIMING INSTRUCTIONS
The headlamps should be aimed with the proper beam-
setting equipment, and in accordance with the equipment
manufacture's instructions.
If there are any regulations pertinent to the aiming
of headlamps in the area where the vehicle is to be
adjust to as to meet those requirements.
Alternately turn the adjusting bolts to adjust the head-
lamp aiming. If beam-setting equipment is not available,
proceed as follows:
1. Inflate the tires to the specified pressure and remove
the load from the vehicle except a driver, spare tire,
and tool.
2. The vehicle should be placed on the flat floor.
BODY ELECTRICAL SYSTEM
3. Draw vertical lines (Vertical lines passing through
respective head lamp centers) and a horizontal line
(Horizontal line passing through center of head-
lamps) on the screen.
4. With the head lamp and battery in normal condition,
aim the head lamps.
Make the vertical and horizontal adjustment of the
lower beam to the standard values by using the
adjusting knobs.
ETA9230A
ETHA0758
W2
Wi
W3
ETHA075A
H1 : Height between the head lamp bulb center and ground (low beam)
H2 : Height between the head lamp bulb center and ground (high beam)
H3 : Height between the fog lamp bulb center and ground
W1 : Distance between the head lamp bulb center (low beam)
W2 : Distance between the head lamp bulb center (high beam)
W3 : Distance between the fog lamp bulb center
ETHA290A