Hyundai trajet Shop Manual page 34

INTERIOR
4. Glue the rubber dam to the inside surface of the
windshield glass around the entire edge as shown,
to contain the sealant during installation.
Part
IIAII
Remarks
Upper
12.5mm constant
Glass molding
Side
sub
Glass molding
Dam
Windshield glass
A
ESHA050E
5. Install the windshield glass molding without any
gaps.
X60-027A
6. Apply a light coat of glass primer to the outside of
the dam.
NOTE
1. Never touch the surface applied primer with your
hand.
If you do, the adhesive may not bond to the glass
properly, causing a leak after the windshield
glass is installed.
2. Do not apply body primer to the glass.
3. Keep water, dust, and abrasive materials away
from the surface applied primer.
SD -33
ESDA235E
7. Apply a primer to the lower glass as shown.
20mm
ESHA05DF
8. Apply a sealant around the edge of the glass.
Sealant
Molding
--4J~=::::===Y=-----""'-
UPPER AND SIDE
ESDA235A
20mm
LOWER
ESHAOSOG
NOTE
Apply the adhesive within 5 minutes after applying
the primer to the glass.
9. Apply a light coat of body primer to the angI-
nal sealant remaining around the window opening