Check Operating Condition After Installation - Hyundai trajet Shop Manual

EXTERIOR
CHECK OPERATING CONDITION AFTER
INSTALLATION
ESHA0900
If the glass panel movement is difficult, check and adjust.
1. Make sure the battery voltage is normal.
2. Make sure that the sunroof sliding unit is free of
abrasive materials.
3. Make sure that, when the glass panel opens, the
rear position of the panel does not interfere with the
roof panel. If interference occurs, fully open the
glass panel and move the stopper forward.
NOTE
If the stopper is moved forward too far, it may cause
malfunction or leaks. Make sure the gap between
the glass panel and roof panel is not more than 0.3
mm.
4. Measure the driving force of the motor, and adjust it
to 15-25 kg (33.1-55.7Ib) with the torque adjustment
nut on the motor.
15-25 Kg
ESA9075D
5. After adjustment, be sure to lock the nut with the
pawl washer.
Torque adjusting nut
ESA9075E
ADJUSTMENT
ESHA0950
Adjust the difference between the height of the glass
panel and the roof panel.
Front side: 0 (+0, -1.0) mm
Rear side: 0 (+1, +0) mm
If the difference is not as specific, adjust the following
procedure.
Roof panel
Glass panel
ESA9011J
1. Loosen the front screw and rear screw. Adjust the
height between the glass panel and roof panel.
ESA90111
2. Loosen the nuts holding the glass panel and adjust
the gap between the glass panel and roof panel.
ESA9011K