Hyundai trajet Shop Manual page 37

SO -36
Apply primer
ESDA235E
7. Apply a light coat of body primer to the origi:'
nal sealant remaining around the window opening
flange. The glass should be installed within 10 min-
utes after you apply the primer.
8. Apply a sealant around the edge of the glass.
Sealant
Glass
Molding
_-A.~~---b'''---->lL-
ESHA150A
NOTE
Apply the adhesive within 5 minutes after applying
the primer to the glass.
9. Use suction cups or the special tool, lower the glass
over the opening, align it with the marks made in
step 3 and set it down on the sealant.
1O. Scrape or wipe excess adhesive off with putty knife
or gauze. Fill all cavities around the tailgate glass.
09861-31400
ESDA230D
11. Periorm a water-leak test for the tailgate glass.
Use a cold water spray, being careful not to direct
a poweriul stream of water on the new adhesive
BODY (INTERIOR & EXTERIOR)
material. Allow water to spill over the edges of the
glass.
12. If there are leaks, dry the affected area, then apply
sealant.
ESDA235G
13. Install the removed parts.
CAUTION
1. Keep the windshield dry for the first hour after
installation.
2. Let the car stand for at least four hours after
windshield installation. If the car has to be used
winthin the first 8 hours, it must be driven slowly.
3. Take care not to slam the doors with all the
windows rolled up.
4. Take care not to twist the vehicle excessively
(such as when going in and out of driveways at
an angle or driving over rough, uneven roads).