Adjustment; Door Position; Door Striker - Hyundai trajet Shop Manual

BD -12
ESHA015H
9. Remove the door key cylinder.
ESHA015J
10. Loosen the bolts holding the handle outside front
door, the latch, and the door lock actuator.
Remove the wire harness and the front door module.
ESHA015K
11. Remove the weather strip outside door belt.
ESHA015L
12. Remove the outside rear view mirror.
BODY (INTERIOR
&
EXTERIOR)
ESHA015M
13. Installation is the reverse of the removal process.
When installing the door trim seal, butyl tape should
not be placed over the area when installing the door
trim fastener.
ADJUSTMENT
ESHA0400
DOOR POSITION
Check for a flush fit with the body, then check for an
equal gap between the front and rear, top and bottom
door edges and the body. The door and body edges
should also be parallel.
CAUTION
Attach protective tape to the fender edges where the
hinge is installed.
ESA9095A
DOOR STRIKER
Make sure the door is not loose, and that it latches
securely without slamming. If necessary, adjust the door
as follows:
1. Draw a line around the striker plate for reference.
2. Loosen the striker screws, and move the striker IN
and OUT to make the latch fit tighter or looser.
Move the striker UP and DOWN to align it with the
latch opening. Then lightly tighten the screws and
recheck.