Troubleshooting - Hyundai trajet Shop Manual

GENERAL
TROUBLESHOOTING
ESHA0150
SD -5
Trouble symptom Probable cause Remedy
Water leaks from sunroof Dirt accumulated in drain pipe Clear dirt inside of drain pipe
Clogged drain pipe Blow air into drain pipe to remove
dirt
Broken or dislocated drain pipe, defective or Check pipe installation and flange
cracked clip
contact
Deteriorated roof lid weatherstrip Replace
Excessive roof lid-to-body clearance and Adjust
improperly fitted weatherstrip
Wind noise Loose or deformed deflector Retighten or replace
Roof lid makes a noise when Foreign particles lodged in guide rail Check drive cable and guide rails for
moved
foreign particles
Loosed guide rails and lid Retighten
Motor runs but lid does not Foreign particles lodged in guide rail Check drive cable and guide rails for
move or moves only halfway
foreign particles
Incorrect engagement of motor pinion with Check for loose motor installation
drive cable and damaged pinion
Decrease in clutch slipping force of motor Adjust
Increased lid sliding resistance or Adjust or replace
interference of lid with drive cables,
weatherstrip, etc. due to maladjustment of lid
Noise in motor (Clutch Incorrect engagement of motor pinion with Check pinion installation and
slipping noise from motor drive cable retighten motor
when lid is fully opened or
I
closed is not an unusual
Worn out or damaged motor pinion bearing Replace motor assembly I
noise.)
Worn out or deformed drive cable Replace
Door glass fails to operate Incorrect window glass installation Adjust position
up and down
Damaged or faulty regulator arm or regulator Correct or replace
Door does not open or close Incorrect door installation Adjust position
completely
Defective door check Correct or replace
Door hinge required grease
Apply grease
Hood does not open or Striker and latch not properly aligned Adjust
close completely
Incorrectly installed hood Adjust
Incorrect hood bumper height Adjust
Water leak through Defective seal Fill with sealant
windshield and rear window
Defective flange Correct