Hyundai trajet Shop Manual page 35

SD -34
flange. The glass should be installed within 10 min-
utes after you apply the primer.
ESDA235F
10. Using suction cups or the special tool, lower the
glass over the opening, align it with the marks made
in step 3 and set it down on the sealant.
11. Scrape or wipe excess adhesive off with a putty
knife or gauze. Fill all cavities around the windshield
glass.
09861-31400
ESDA230D
12. Perform a water-leak test for the windshield. Use
a cold water spray, being careful not to direct a
powerful stream of water on the new adhesive
material. Allow water to spillover the edges of the
glass.
13. If there are leaks,dry the affected area, then apply
sealant.
ESDA235G
14. Install the removed parts.
BODY (INTERIOR & EXTERIOR)
CAUTION
1. Keep the windshield dry for the first hour after
installation.
2. Let the car stand for at least four hours after
windshield installation. If the car has to be used
winthin the first 8 hours, it .must be driven slowly.
3. Take care not to slam the doors with all the
windows rolled up.
4. Take care not to twist the vehicle excessively
(such as when going in and out of driveways at
an angle or driving over rough, uneven roads).