Table of Contents
Advertisement
SD -32
REMOVAL
ESHA1350
1.
To remove the windshield, first remove the following
parts:
1)
Front pillar trims
2)
Inside rear view mirror
3)
Wiper arms
4)
Cowl top cover
5)
Windshield glass molding
ESHA040C
2.
Use the special tool (09861-31100) to cut through
the sealant.
ESDA230B
3.
Make mating marks on the glass and body if the
glass is to be reinstalled.
-~-_.~t!'!----_
- - -
X60-026A
4.
Take out the windshield glass with the special tool
using the Glass Holder.
BODY (INTERIOR & EXTERIOR)
09861-31400
ESDA230D
INSTALLATION
ESHA1400
1.
Using a cutter knife or the special tool, scrape the
old sealant smoothly to a thickness of about 2 mm
(0.08 in.) on the bonding suriace around the entire
windshield flange.
CAUTION
Be careful not to remove more adhesive than neces-
sary, and also not to damage the paintwork on the
body surface with the knife. If the paintwork is dam-
aged, repair the damaged area with touch-up paint.
./!L~;"--
09861-31200
ESDA235B
2.
Clean the body bonding suriace with a sponge
dampened in alcohol or wax and grease remover.
3.
Center a new windshield glass in the opening. Mark
the location by marking lines across the glass and
body with a grease pencil at the four points as
shown.
X60-026A
Advertisement
Table of Contents
Troubleshooting
