Multi Function Switch Removal And Installation - Hyundai trajet Shop Manual

MULTI FUNCTION SWITCH BE -25
REMOVAL AND INSTALLATION
ETHA1050
Prior to removing of the multifunction switch assembly in
vehicles equipped with air bags, be careful to follow the
following:
CAUTION
• Never attempt to disassemble or repair the air
bag module or clock spring. If faulty, replace it.
e
Do not drop the air bag module or clock spring or
allow contact with water, grease or oil. Replace
if a dent, crack, deformation or rust are detected.
I!I
The air bag module should be stored on a flat
surface and placed so that the pad surface is
facing upward. Do not place anything on top of
it.
o
Do not expose the air bag module to tempera-
tures over 93°C(200°F).
o
After deployment of an air bag, replace the clock
spring with a new one.
I!I
Wear gloves and safety glasses when handing
an air bag that has already been deployed.
e
An undeployed air bag module should only be
disposed of in accordance with the procedures
mentioned in the restraints section.
o
When you disconnect the air bag module-clock
spring connector, take care not to apply exce-
sive force.
• The removed air bag module should be stored
in a clean, dry place.
III
Prior to installing the clock spring, align the
mating mark and "NEUTRAL" position indicator
of the clock spring, and after turning the front
wheels to the straight-ahead position, install the
clock spring to the column switch. If the mating
mark of the clock spring is not properly aligned,
the steering wheel may not completely rotate
during a turn, or the flat cable within the clock
spring may be severed, obstructing normal op-
eration of the SRS and possibly leading to seri-
ous injury to the vehicle's driver. To inspect the
clock spring, refer to the restraints section.
1. Remove the air bag module.
ESHA040M
2. Remove the steering wheel.
ESHA040N
3. Remove the steering column upper shroud and
steering column lower shroud.
ESHA0400
4. Loosen the multifunction switch mounting screws
and disconnect the connector. Remove the multi
function switch assembly.
ESHA040P
5. Installation is the reverse of the removal process.