Front Seat Belt Removal And Installation - Hyundai trajet Shop Manual

• Make sure that ignition is "Off".
• Disconnect the negative (-) battery terminal and
make sure it does not come into contact with the
body.
• Wait for about 1 minute.
• Pull the plug out from the appropriate connector
at the gas generator.
.. Loosen the bolt and remove the belt from the
vehicle body.
SEAT
FRONT SEAT BELT
REMOVAL AND INSTALLATION
ESHA1850
1. Loosen the seat belt lower anchor bolt and remove
the center pillar lower trim.
ESHA0401
2. Loosen the seat belt upper anchor bolt.
ESHA045B
3. In case of vehicles equipped with pretensioner seat
belt, disconnect the negative (-) battery terminal and
disconnect the connector from the gas generator
and then remove the retractor.
ESHA040J
4. Installation is the reverse of the removal process.
CAUTION
1. A pretensioner functions one time only. Be sure
to replace the pretensioner seat belt after it is
deployed.
2.
3.
4.
5.
BO -43
Do not attempt to disassemble or· repair the
seat belt pre-tensioner. When it malfunctions,
replace with a
n~VII P~~rtensiQnef:~eat,belt.,;.,
_
J
Be cautious in' handling
a
pre~tensi'oner' 'seat
belt, and dQ not drop it in water, or 9il. If
crushed, damaged, or deformed, replace it with
a new one.
Only connect the battery after installation of
the pretensioner seat belt has been correctly
completed.
Removal of the pretensioner seat belt: