Table of Contents
Advertisement
Red symbols
A red symbol warns of a danger.
– Stop the vehicle.
– Switch the engine off.
– Check the fault. Obtain professional assistance if necessary.
Fault in brake system
BRAKES
Coolant level too low / coolant tem-
perature too high
COOLANT
Engine oil pressure too low
OIL
PRESSURE
Safety First
Fig. 54 Display: Coolant
level warning
⇒ page 77
⇒ page 78
⇒ page 78
Operating Instructions
The red symbols are used to indicate a Priority 1 fault (serious malfunction).
A red symbol is accompanied by three warning chimes. The symbols will keep
flashing until the faults are corrected. If several Priority 1 faults are detected
at the same time, the symbols are displayed one after the other for about 2
seconds.
Fault in the brake system
A fault in the brake system should be repaired as soon as
possible.
If the symbol
flashes in the display, there is a fault in the brake
system. One of the following messages will appear in the display
together with the symbol:
Stop vehicle, check brake fluid and hydraulic fluid levels
Warning! Fault in brake system (ABS) Take vehicle to workshop
– Stop the vehicle.
– Check the brake fluid level ⇒ page 240.
If the ABS fails, the ABS warning lamp
⇒
system fault symbol
.
WARNING
•
Before opening the bonnet and checking the brake fluid level, observe
the warning information in ⇒ page 229, "Work in the engine compart-
ment".
•
If the brake fluid level in the reservoir is too low, this could result in an
accident. Do not drive on! Obtain technical assistance.
Practical Tips
Cockpit
will light up together with the brake
Technical Specifications
77
Advertisement
Table of Contents
