Table of Contents
Advertisement
240
Checking and refilling levels
Removing the wiper blade
– Lift the wiper arm away from the
– Slide the blade adapter in the direction of the arrow and remove
⇒ page 239, fig.
the blade
Fitting the wiper blade
– With one hand, hold the top end of the wiper arm.
– Place the blade as shown in the
the adapter along until it engages.
Check the condition of the wiper blade regularly. Change as required.
If the windscreen wiper scrapes, it should be replaced if damaged, or
cleaned if soiled.
If this is not sufficient, refer to a qualified workshop.
WARNING
Do not drive unless you have good visibility through all windows!
•
Clean the windscreen wiper blades and all windows regularly.
•
The wiper blades should be changed once or twice a year.
Caution
•
A damaged or dirty window wiper could scratch the rear window.
•
Never use fuel, nail varnish remover, paint thinner or similar products to
clean the window.
•
Never move the windscreen wiper by hand. This could cause damage.
glass⇒ page 239, fig. 183
183.
⇒ page 239, fig. 184
and slide
Brake fluid
Checking the brake fluid level
The brake fluid level can be checked visually.
The brake fluid level must be between the "Min" and "Max"
ings.
The fluid level may drop slightly after a period of time due to the automatic
compensation for brake pad wear. This is quite normal.
However, if the level goes down noticeably in a short time, or drops below the
"Min" mark, there may be a leak in the brake system. If the fluid level in the
reservoir is too low, this will be indicated by the brake warning lamp
⇒ page 70 and ⇒ page 77. If this should happen, take the vehicle to a qual-
ified workshop immediately and have the brake system inspected.
Fig. 185 Engine compart-
ment: markings on brake
fluid reservoir
⇒ fig. 185
mark-
Advertisement
Table of Contents
