Table of Contents
Advertisement
Topping up the engine oil
– Unscrew cap
from oil filler opening
– Carefully put in the specified grade of oil ⇒ page 231, adding
0.5 litres at a time.
– After two minutes, check the oil level once again ⇒ page 232.
– Where necessary, add more engine oil.
– Replace the oil filler cap carefully and push the dipstick all the
way in.
WARNING
•
When refilling with oil, make sure no oil falls onto hot engine parts.
Failure to comply could result in fire.
•
Wash your skin thoroughly if it comes into contact with engine oil.
Safety First
Fig. 178 In the engine
compartment: Engine oil
filler cap
⇒ page 301, fig.
248.
Operating Instructions
Caution
•
The oil level must never be above area
lytic converter or the engine. Contact a qualified workshop to drain the engine
oil if necessary.
•
No additives should be used with engine oil. Any damage caused by the
use of such additives would not be covered by the factory warranty.
For the sake of the environment
•
Oil must not be disposed of in the drain or on the ground.
•
Always observe legal requirements when disposing of empty oil
canisters.
Cooling system
Coolant fluid
The purpose of the coolant fluid is to carry heat away from the
engine. The correct amount of antifreeze is decisive in
preventing the cooling system from freezing in winter.
The vehicle's engine cooling system is filled for life at the factory, so no
coolant needs to be changed. The coolant fluid consists of a mixture of water
and antifreeze G12++. This is a glycol-based antifreeze with anti-corrosion
additives.
Coolant fluid additive
The amount of antifreeze required depends on the temperatures to be
expected in the winter season. If the antifreeze concentration is too low the
coolant can freeze, resulting in failure of the cooling system and heater.
Practical Tips
Checking and refilling levels
A
a
. This could damage the cata-
Technical Specifications
233
Advertisement
Table of Contents
