Table of Contents
Advertisement
Fitting the ball joint (step 1)
– Remove the cover piece
A
below the bumper as far as it will go. The cover piece is held
1
automatically in the open position.
– Make sure the mounting fixture is clean. If not, clean it ⇒
Cont ⇒ page 207, "Fitting the ball joint (step 2)".
WARNING
It is important to keep the mounting fixture clean. Otherwise the ball joint
may fail to engage safely and securely. This could lead to an accident.
Safety First
Fig. 163 Rear bumper:
Open the cover piece
A
⇒ fig. 163
on the mounting fixture
2
Operating Instructions
Fitting the ball joint (step 2)
.
Practical Tips
Trailer towing
Fig. 164 Removable
towing bracket: Ball joint
Fig. 165 Removable
towing bracket: Ball joint
Technical Specifications
207
Advertisement
Table of Contents
