Table of Contents
Advertisement
Setting the spring mechanism to the ready position (if required)
A
⇒ page 208, fig. 166
– Insert the key
1
and turn it towards the red marking.
– Pull out the knob in direction
until the locking pin
out visibly ⇒
.
Inserting the ball joint
– With the spring mechanism in the ready position, insert the ball
joint into the mounting fixture and push it upwards
in the direction indicated (arrow) ⇒
fig. 167
into position automatically. You should now clearly hear it click
into place.
– Lock the ball joint by turning the key to the green marking.
– Remove the key.
Cont ⇒ page 209, "Fitting the ball joint (step 4)".
WARNING
•
If it is not possible to set the spring mechanism to the ready position as
described above, do not use the ball joint. Please contact a qualified work-
shop.
•
To avoid injury, keep your hands away from the knob or cover piece
when inserting the ball joint in the mounting fixture. Otherwise, you could
be injured.
Safety First
in the lock on the knob
A
, hold and turn in direction
A
A
engages and the release pin
2
⇒ page 208,
. It should lock
Operating Instructions
Fitting the ball joint (step 4)
A
B
A
moves
3
Practical Tips
Trailer towing
Fig. 168 Removable
towing bracket: Safety
check
Fig. 169 Rear bumper:
Pulling down the power
socket
Technical Specifications
209
Advertisement
Table of Contents
