Table of Contents
Advertisement
Activating/Deactivating
Activating
– Engage reverse gear or
– Press the button
gear selector gate. You will hear a brief confirmation tone and the
LED on the switch will light up.
Deactivating
– Drive forward faster than 10 km/h, or
– Press the
button or
– Switch off the ignition or
– Disengage the reverse gear.
Safety First
Fig. 150 Centre console:
switch for parking aid
⇒ fig. 150
on the centre console
Operating Instructions
WARNING
•
The parking aid is not a replacement for driver awareness. The driver is
personally responsible for safe parking and other manoeuvres.
•
The sensors have blind spots in which obstacles are not registered.
Always look out for small children and animals because the system will not
always detect them. Always pay attention when reversing to avoid acci-
dents.
•
Always keep a close eye on the area around the vehicle and make full
use of the rear view mirrors.
Caution
Please note that low obstacles detected by the system may no longer be
registered by the sensors as the vehicle moves closer, so the system will not
give any further warning. Certain kinds of obstacles (such as wire fences,
chains, thin painted posts or trailer draw bars, etc) may not always be
detected by the system, so take care not to damage the vehicle in such cases.
Note
or on the
•
Please refer to the notes on towing ⇒ page 179.
•
There is a slight delay in the picture display.
Towing bracket*
In towing mode, the rear parking aid sensors are not enabled when you select
reverse gear or press the switch
towing brackets that are not factory fitted. This results in the following restric-
tions:
Practical Tips
. This function may not be guaranteed on
Technical Specifications
Driving
179
Advertisement
Table of Contents
